Table of Contents
Advertisement
Appendix B Installing the Slide Assembly in the Rack
Determining the Mounting Position
100
Procedure (continued)
Insert a temporary support screw into each retma rail, just below
3
the desired position of the slide assembly bracket.
Use any long screws that fit into the retma rail holes.
Make sure the support screws are level with one another.
4
Leave the screws extended out of the retma rails at least 0.625 in.
(16 mm) so they will support the slide assembly mounting brackets
during installation.
ATL P1000 Series User's Guide
Advertisement
Table of Contents
