Flushing The Print-Block Heater - Stratasys J850 User Manual

Stratasys J850/J835 User Guide
5. Select the check box, and click Next.
6. Click Done in the final wizard screen.

Flushing the Print-block Heater

If the printer is configured to print in High Speed mode (with three model
materials), or in Super High Speed mode (with one model material), the print-
block heater needs to be periodically flushed. This is necessary to prevent
possible clogging of unused material channels in these modes. A reminder
message appears if 250 printing hours have passed since the print-block
heater was last flushed.
The time required for completing this procedure depends on the materials
loaded in the printer. A time estimation appears in the wizard before starting
the flushing process.
DOC-18001 Rev. H
Figure 4-134 Weight stabilization
4 Operating and Maintaining the Printer
4-91