Develop ineo 25e Manual page 66

4
Setting the memory transmission / real time transmission
There are two types of automatic transmission; memory transmission, which starts transmission after the
document is scanned, and real time transmission, which performs transmission while the document is being
scanned.
This explanation indicates the procedure for selecting either transmission method for a single fax transmis-
sion.
- Memory transmission transmits the document after scanning the document into memory. This allows
you to take the document and leave without waiting for the transmission to end, enabling you to save
time.
- Real time transmission directly transmits the document to the other fax machine without scanning the
document into memory. Transmission starts after the transmission operation, which allows you to easily
confirm that the fax is sent to the other machine.
1
Load the document.
2
Press [Fax] on My MFP Menu screen.
% If My MFP Menu screen is not displayed, press <Mode> repeatedly until "Fax Ready" screen is dis-
played.
3
Press [Advanced].
4
Press [MemoryTx].
5
Select [ON] to perform memory transmission or [OFF] to perform real time transmission, and press [En-
ter].
6
Press [Close].
7
Specify the destinations, and press <Start>.
% For details on specifying the destinations, see page 6-3.
% If you loaded the document in the automatic document feeder, this concludes the procedure.
% If you loaded the document on the document glass, the message "Set next document." is displayed
when the loaded documents have been scanned. Load the next document, and press [Next Doc].
Press [Tx Start] to start transmission.
d
To send the fax using real time transmission, load the document into the auto document feeder. Even if real
time transmission is set, the machine will automatically switch to memory transmission for broadcast or when
the document is loaded on the document glass.
4-10
Basic faxing 4.1
ineo 25e