Develop ineo 25e Manual page 22

2
5
Connect the USB memory to the machine.
6
Press <Start>.
% When you have loaded the document on the automatic document feeder, this will conclude the op-
eration.
% When you have loaded the document on the document glass, the following message will appear
when the first page of the document is scanned.
7
Load the next document, and press [Next Doc].
8
Repeat step 7 to scan all the documents.
% To finish scanning, press [Complete].
9
When the message "Scan Ready" is displayed, disconnect the
USB memory.
d
If you connect USB memory when the machine is in the ready state,
the following display will appear. Select [Scan To USB]. Then follow
the procedures from step 6.
2-12
Basic scanning 2.1
ineo 25e