Reading The Transmission Report - Develop ineo 25e Manual

7.1 Checking the transmission report
7.1.2

Reading the transmission report

Number
1
2
3
4
5
6
7
8
9
10
11
12
*1 When a communication error code and error message is printed, confirm the content of the error and
perform the transmission again. For details, see page 9-3.
ineo 25e
Item Description
Destination The destination name, fax number, or e-mail address
Type FAX: Fax transmission
Mode The resolution used for the communication
Start Time The time the communication started
Time The time that elapsed from when the communication started until
when the communication ended
Page The number of pages transmitted
Note The type of communication is printed for the following types of
communication:
• Manual Tx
• Broadcast
• PC-Fax Tx
Result OK:
* :
# :
Code :
Details Blank when the communication ends without an error.
When a communication error occurs, the error message is printed
TTI and TTI Num- The registered TTI and TTI number
ber
Sender The user name (only when a user is logged in)
− The date and time the report was printed
Completed normally
ECM Mode transmission
Super G3 transmission
The communication error code
*1
*1
7
7-5