Fm11 Configuration - Teltonika FMA110 User Manual

1. Standard with mini-USB cable.
2. USB PCB (female) + mini-USB cable.
please contact Teltonika, LTD sales representative and provide CAR
manufacturer, model and year information.
Attention! Do not swap CAN L and CAN H lines.
Do not swap power supply lines. Make sure that voltage do not exceeds 30V.
Power supply lines should be connected at the end of installation work.
9.5

FM11 Configuration

FMA110 shares the same USB port for connecting LV-CAN200 or ALL-CAN300 adapter and
configuring device with PC.
FMA110 can be configured using "SCAN" function or "Offline Configuration"
SCAN function – is in use when FMA110 is connected to CAN adapter (Figure 57), then wait
10s (Note, that car engine must be started), disconnect adapter from FMA110, and connect PC
USB cable to FMA110 Device (Figure 57). It is very important not to disconnect FMA110 from
power source during this operation, because if FMA110 is reconnected all received CAN bus data
will be lost. FMA110 remembers received data from LV-CAN200 or ALL-CAN300 and at the end of
the procedure when "SCAN" button is pressed, user will see all CAN data which is sent by
adapter. Enable CAN data which needs send to server and save configuration pressing "Save"
button.
To configure CAN data:
Figure 56 ALL-CAN300 Adapter connection cable pinout
Attention! Ordered LV-CAN200 and ALL-CAN300 packaging may vary:
Attention! For detailed connection diagram of adapter to light vehicle
97