9.2.1
LV-CAN200 and ALL-CAN300 program number configuration via SMS command
LV-CAN200 and ALL-CAN300 program number can be set remotely, using SMS
command:
lvcansetprog X
X is new program number value.
9.2.2
Selecting LV-CAN200 and ALL-CAN300 program number manually
Steps to set program number:
Hold SWITCH down till LED stars blinking
Release the SWITCH
Then LED starts blinking and counting first digit of program number, (one blink
means digit 1, two blink digit 2 etc.)
To stop counter push SWITCH
Release the SWITCH, then LED starts blinking and counting second digit of program
number
To stop counter push SWITCH
Release the SWITCH, then LED starts blinking and counting third digit on program
number
To stop counter push SWITCH
Release the SWITCH, then LED starts blinking and counting fourth digit on program
number
To stop counter push SWITCH
Release SWITCH, if programming is succeded LED will blink 10 times
94