Teltonika FMA110 User Manual page 98

1. In car, connect LV-CAN200 or ALL-CAN300 to CAN bus and to the FMA110 device (Figure
57), wait 10 seconds. Note, that car engine must be started.
2. Disconnect LV-CAN200 or ALL-CAN300 from FMA110, and connect PC USB cable to
FMA110 Device (Figure 58). It is very important not to disconnect FMA110 from power
source, because then all CAN data will be lost.
CAN bus data which can be read from your car is shown in "Light or ALL Vehicles Can
adapter supported cars" document.
Offline configuration – user can select which CAN data will be red from LV-CAN200 or ALL-
CAN300 and directly sent to server without connection to adapter. Please note that parameters
depend on vehicle manufacturer and vehicle model. Please for further information check "Light
and All Vehicles Can adapter supported cars" document.
There are two types of operations with CAN data elements:
 Monitoring of CAN bus data
 CAN bus data event capturing
Monitoring method is used when user wants to receive CAN data on regular basis, for
example every 20 seconds.
Event functionality is used to store additional AVL packet when state of CAN element is
changing. For example Speed changes, low fuel level, engine temperate, etc.
Send data to server field – allows enabling CAN element so it is added to the AVL data
packet and sent to the server. By default, all CAN elements are disabled and FMA110 records
only GPS data.
It is possible to set CAN message priority: On Low Priority, On High Priority, and On Panic.
Regular packets are sent as Low priority records. When low priority event is triggered, FMA110
makes additional record with indication what was the reason for that was CAN element change.
When High priority is selected, module makes additional record with high priority flag and sends
Connection
LV-CAN200
All-CAN300
Figure 57 Connect adapter LV-CAN100 to FMA110
Figure 58 Connect FMA110 to PC and configure
U
FMA110
SB
98