Teltonika FMA110 User Manual page 106

received data
10 – CAN not connected, require connection
11 – CAN connected
Example: Byte0 - 0F hex –
CAN4, CAN3, CAN2,
Byte1:
Not used
Byte2:
0x20 – bit appears when any operate button in car
was put
0x40 – bit appears when immobilizer is in service
mode
0x80
– immobiliser, bit appears during introduction
of a programmed sequence of keys in the car.
Byte3:
0x01 – the key is in ignition lock
0x02 – ignition on
0x04 – dynamic ignition on
0x08 – webasto
0x20 – car closed by factory's remote control
0x40
– factory-installed alarm system is actuated (is
in panic mode)
0x80 – factory-installed alarm system is emulated
by module
Byte4:
0x01 – parking activated (automatic gearbox)
0x10 – handbrake is actuated (information available
only with ignition on)
0x20
– footbrake is actuated (information available
only with ignition on)
0x40 – engine is working (information available
only when the ignition on)
0x80 – revers is on
Byte5:
0x01
– Front left door opened
0x02
– Front right door opened
0x04 – Rear left door opened
0x08 – Rear right door opened
0x10 – engine cover opened
0x20 – trunk door opened
Byte6:
0x01
– car was closed by the factory's remote
control
0x02 – car was opened by the factory's remote
control
0x03 – trunk cover was opened by the factory's
remote control
0x04 – module has sent a rearming signal
0x05 – car was closed three times by the factory's
remote control
- High nibble (mask 0xF0 bit)
00001111 binary
CAN1
106