Start Speed (Id=1281); Ignition Off Timeout (Id=1282); Trip Continuous Distance Counting (Id=1283); Remember Ibutton Id (Id=1284) - Teltonika FMA110 User Manual

8.6.22 Start Speed (ID=1281)

This parameter represents speed, which is detected as minimum speed to indicate TRIP
START and generate event.
Minimum Maximum
value value
0 255

8.6.23 Ignition Off Timeout (ID=1282)

This parameter represents timeout to wait if ignition is off in order to detect TRIP STOP and
generate event.
Minimum Maximum
value value
0 65535

8.6.24 Trip Continuous distance counting (ID=1283)

For this feature I/O#11 Trip distance must be enabled. If I/O Trip distance is enabled, and
Continuous distance counting variable is set to Continuous (value 1), TRIP distance is going to be
counted continuously (from TRIP start to TRIP stop) and shown as I/O Trip distance value.
Minimum Maximum
value value
0 1

8.6.25 Remember iButton ID (ID=1284)

This parameter enables/disables Remember iButton ID functionality. 0 – disable, 1 – enable.
Minimum Maximum
value value
0 1

8.6.26 Odometer value (ID=1285)

This parameter represents start odometer value.
Minimum Maximum
value value
0 -

8.6.27 Geofencing

In this chapter it is explained how to get all parameters for the first Geofence zone (all ID
numbers are for the 1
with the IDs of all the rest Geofence zones.

8.6.27.1 Frame border (ID=1020)

Geofence border thickness, measured in meters.
Recommended
value
-
Recommended
value
-
Recommended
value
-
I/O#11 – Trip distance (ID = 1410-
Recommended
value
-
Recommended
value
I/O#27 – Total distance (ID=1130-
-
st zone). And at the end of the chapter (part 8.6.10) is presented a table
Goes with (depends on)
parameters
Tip (ID=1280)
Goes with (depends on)
parameters
Trip (ID=1280)
Goes with (depends on)
parameters
Trip (ID=1280)
1415)
Goes with (depends on)
parameters
Trip (ID=1280)
iButton List (ID=3500-3999 )
Goes with (depends on)
parameters
1135)
Value
type
U8
Value
type
U16
Value
type
U8
Value
type
U8
Value
type
U8
80