Table of Contents
Advertisement
6.1.9
readio #
Response details
ID
Value
Example: I/O ID:3 Value:0
6.1.10 setdigout ## Y1 Y2
Sets digital outputs to ON or OFF state (for some time if needed). Value is written as a row
for OUT1 and OUT2 values.
Example: 'setdigout 01 0 5' will set OUT2 to high level for 5 seconds, while OUT1 to low
level.
To ignore one digital output value and make ON/OFF state only to another digital output
enter question mark.
Example: 'setdigout ?1' will set OUT2 to high level for indefinite period of time while OUT1
remains as it was set before.
6.1.11 setdigoutX Z Y
Sets selected digital output to on or OFF state for a defined period of time.
Example: 'setdigout2 1 5' will set DOUT2 to high level for 5 seconds.
6.1.12 getparam ####
Read parameter value. ID consists of 3 or 4 digits. Detailed list of parameters and IDs can
be found in chapter number 8 "Parameter List".
Example: 'getparam 1115' command will request server IP address.
6.1.13 setparam ####
Sets new value for parameter. ID consists of 3 or 4 digits. Detailed list of parameters and
IDs can be found in chapter number 8 "Parameter List"
Example: 'setparam 1115 127.0.0.1' will change configured IP address.
6.1.14 getparam 1271 X/212 X
X values can be 1,2,3.
If X = 1, Operator codes from 0-19 are read from configuration and sent via SMS.
If X = 2, Operator codes from 20-39 are read from configuration and sent via SMS.
If X = 3, Operator codes from 40-49 are read from configuration and sent via SMS.
If X = any other, Operator codes from 0-19 are read from configuration and sent via SMS.
6.1.15 setparam 1271 X/212 X
If X is from 0 to 49, X means index of operator code which has to be configured. Up to 20
operator
codes
may
24602,24603,24605 ,here 16
are left unchanged in the configuration.
Description
I/O element ID
I/O Element value
be
configured
th
, 17
th
and 18
th
operator codes are set. Note! Other operator codes
in
1
SMS.
Example:
Setparam
1271
16
57
Advertisement
Table of Contents
