Teltonika FMA110 User Manual page 43

X2 or R – geofence zone upper right corner X coordinate (longitude) or radius of circle
when Circular zone is used (radius in meters);
Y2 – geofence zone upper right corner Y coordinate (latitude);
AutoGeofencing settings
AutoGeofence – the last known position after movement = off. If your car's being
taken away – you can be notified. The shape and size of the geofence zones are
parameters. It is possibility to state whether entering in or out of the geofence triggers an
asynchronous message.
AutoGeofencing option can be configured by following parameters visible in figure 33
below.
Activate – Enable or Disable AutoGeofence functionality.
Activation TMO – Time period before Geofence is activated after vehicle stops.
Deactivate By:
Ignition – If ignition (configured Ignition Source) becomes high it will disable
AutoGeofenze Zone.
IButton – if iButton is attached it will disable AutoGeofence Zone.
Edit iButton List – if list is not empty, attached iButton is tested against an iButton list, if
match is found AutoGeofence zone is disabled.
Priority – Priority of generated event, which will be applied to saved record.
Enter Event – Event generation on Geofence entrance.
Exit Event – Event generation on Geofence exit.
On Both – Event generation on Geofence entrance Or exit
Note that AutoGeofencing does not require entering coordinates, instead it requires GPS
visibility. If vehicle stopped and activation timeout has passed, an AutoGeofence will be created
Figure 37 Geofence configuration
43