Teltonika FMA110 User Manual page 99

event packet immediately to the server by GPRS. Panic priority triggers same actions as high
priority, but if GPRS fails, it sends AVL packet to server using SMS mode if SMS is enabled in SMS
settings.
Data Acquisition Type – defines when to generate event – when value enters defined range,
exits it or both, also is possible to select event which you want to generate then you change
values, like crossing both values in high and low levels (Hysteresis).
High and Low levels – defines CAN value range. If CAN value enter or exits this range,
FMA110 generates event by "Data Acquisition Type" settings. Figure 59 show example of
FMA110 CAN configuration.
Available CAN Bus IO parameters and configuration can be found in Configurators LVCAN
tab (Figure 59) and in next chapter "Parameters ID".
Send data with 0, if ignition is off. Depending on LVCAN/ALLCAN I/O parameters and
ignition status, FMA110 can send locked (last known) LVCAN/ALLCAN I/O parameters values,
reset values (set to 0) and active (real time) parameters values. When ignition is off,
LVCAN/ALLCAN I/O parameters values sent to server are:
Figure 59 Configurator example
Speed
Accelerator pedal position
Total fuel used
reset
reset
lock
99