After power supply connecting, LED shines continuously. It means that device awaits for calibration.
Calibration process has to be carried out when CAN-BUS twisted pair is tightened on SIMPLE-CAN and
when the ignition is ON. Please press the switch shortly and wait for the LED to start blinking every 1
second. Automatic calibration process takes up to 10 seconds depending on the vehicle's model. Correct
calibration process is confirmed by LED's every 2 seconds blink (when the CAN-BUS is active). When the
CAN-BUS enters sleep mode, SIMPLE-CAN device does it also and takes 1,6mA/12V. In the sleep mode LED
does not shine. If after calibration process LED shines continuously, it means that device is not calibrated
yet, CAN-BUS transmission has failed or ignition during calibration was not ON.
9.4
Connecting FMA110 Can adapters ALL-CAN300 and LV-CAN200
Connect USB Plug to FMA110 device, connect Light Vehicles Can adapter to other end of
the cable.
Connect Light Vehicles Can adapter Pin 1 and Pin 2 to cars CAN bus. CAN interface location
of the supported light vehicle is described on mounting scheme.
Connect car power supply lines to Pin 3 positive, Pin 4 Negative.
Pins 9,10 connection is optional it depends on exact car model.
For exact pinout see sticker on Light Vehicles Can adapter.
Figure 55 Simple CAN connection
Figure 55 LV-CAN200 Adapter connection cable pinout
96