Features Settings; Scenarios Settings - Teltonika FMA110 User Manual

Table of Contents

5.14 Features settings

For more information about available Scenarios, Trip, Geofencing and iButton list, refer to

5.4 chapter.

In Scenarios window four different scenarios are available to use. More than one scenario

can manage the same DOUT. If DOUT Control is disabled, scenarios can only generate events

without digital output activation.

Digital Output (open drain grade) usage in scenarios:

 Green Driving

DOUT1/DOUT2 (optional) is ON for:

 3sec. if detected value is over (0; 30] % from preconfigured allowed value

 5sec. if detected value is over (30; 50] % from preconfigured allowed value

 7sec. if detected value is over (50; -] % from preconfigured allowed value

After period of time DOUT1/DOUT2 is turned OFF.

 Over Speeding

If Dout Control is disabled, scenario only generate events without digital output activation.

If Dout Control is enabled DOUT1/DOUT2 (optional) is ON, while vehicle speed exceeds the

parameter value. DOUT1/DOUT2 remains active until current speed decreases below the

parameter value.



Jamming Detection

When this scenario is enabled and device modem is being jammed, then a low priority

event is generated. Jamming functionality allows to set Jamming Sensitivity to Low, Medium or

High. Jamming Timeout, Jamming Dout control and Jamming Pulse Duration can be configured. If

Jamming Pulse Duration is > 0, then jamming is activated (digital output will be activated for this

time period and will be deactivated after time expires). If jamming ends before timeout occurs,

then timeout countdown will reset. Jamming can be deactivated with iButton. When jamming

Figure 33 Scenarios configuration

Table of Contents