Slave Role Non-Volatile Memory Parameters - TDK-Lambda G+1U 5kW User Manual

Function
Enable registers
Event registers
Power-On Status Clear
Display Brightness
Display Dim Delay [S]
Display Dim Brightness
Factory Calibration Parameters
Power Sink *1
Table 5-3: Single or Master Roles Non-Volatile Memory Parameters
1. LAN non-volatile memory parameters are not affected (for default parameters, refer to Table
2-7: LAN Non-Volatile Memory Parameters). The only affected parameter is the Host Name
which is updated to default due to system identification update.
2. *1 Available for power supplies equipped with a Power Sink module.
5.9.10.2

Slave role non-volatile memory parameters

Refer to Table 5-4: Slave Role Non-Volatile Memory Parameters for the default non-volatile
memory parameters set when power supply changes its role to Slave.
Function
Power Supply Start Mode
Power Supply Output State
Voltage Set Point [V]
Current Set Point [A]
Over Voltage Protection (OVP) [V]
Under Voltage Level (UVL) [V]
Under Voltage Protection (UVP) Mode
Under Voltage Protection (UVP) Delay [S]
Fold-Back Mode
Fold-Back Delay [S]
Constant Power Function
Constant Power Set Point [W]
Slew Mode
Voltage Slew Up / Down [V/mS]
Current Slew Up / Down [A/mS]
Internal Resistance Function
Internal Resistance Set Point [Ω]
Voltage Reference Programming Source
Current Reference Programming Source
Single or Master Role
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
ON
NOTES
Slave Role
SAFE
OFF
0
1.05 * RATED
1.1 * RATED or 1.2 * RATED (Model Dependent)
0
OFF
01.0
OFF
01.0
OFF
RATED VOLTAGE MULTIPLYED BY RATED CURRENT
OFF
999.99
SAME AS MASTER POWER SUPPLY
OFF
0.001
DIG
DIG
159