TDK-Lambda G+1U 5kW User Manual page 175

Function
Analog Mode Current Limit (OCL)
Analog Programming & Monitoring Range [V]
Programmable Pin 1
Programmable Pin 2
Front Panel Remote Mode
Front Panel LOCK
Output Sense (LOC / REM)
Interlock (ILC) Function
Enable (ENA) Function
Enable (ENA) Polarity
Power Supply OK (PS_OK) Delay [S]
Preload
Communication Interface
Communication Power Supply Address
Communication Baud Rate [Baud]
Communication Language
LAN parameters
Special Voltage Upper Limit (SVUL)
Special Current Upper Limit (SCUL)
Enable registers
Event registers
Power-On Status Clear
Display Brightness
Display Dim Delay [S]
Display Dim Brightness
Factory Calibration Parameters
Power Sink *1
Table 5-4: Slave Role Non-Volatile Memory Parameters
1. Slave unit parameters read by communication might not reflect actual system status. i.e.,
slave power supply does not reflect OCL mode, Constant Power mode, Slew-rate mode, etc.
2. LAN non-volatile memory parameters are not affected (for default parameters, refer to Table
2-7: LAN Non-Volatile Memory Parameters). The only affected parameter is the Host Name
which is updated due to system identification update.
3. *1 Available for power supplies equipped with a Power Sink module.
Slave Role
OFF
5
OFF
OFF
LOCAL
OFF
LOC
OFF
OFF
REV
00.01
SAME AS MASTER POWER SUPPLY
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
Not Affected (Preserves Setting), except Host Name
RATED
RATED
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
Not Affected (Preserves Setting)
ON
NOTES
160