Chapter 10: Maintenance; Introduction; Units Under Warranty; Periodic Maintenance - TDK-Lambda G+1U 5kW User Manual

CHAPTER 10:
10.1

Introduction

This chapter provides information about maintenance, calibration, and troubleshooting.
10.2

Units under Warranty

Units requiring repair during the warranty period should be returned to a TDK Lambda authorized
service facility.
Further technical assistance, if needed, may be obtained at TDK-Lambda Technical Centre:
https://www.emea.lambda.tdk.com/about_global
Repairs performed by other than the authorized service facilities may void the warranty.
10.3

Periodic Maintenance

For standard models (without air filter), NO routine maintenance of the power supply is required
except for periodic cleaning.
To clean the device:
1. Disconnect the unit from the AC supply and allow 30sec. for discharging internal voltage.
2. To clean the front panel and the metal surfaces, use a mild solution of detergent and water.
The solution should be applied onto a soft cloth, and not directly to the surface of the unit.
Do not use aromatic hydrocarbons or chlorinated solvents for cleaning. Use low pressure
compressed air to blow dust from the unit.
3. For units with optional air filter assembled, refer to Air Filter Kit Manual for maintenance
instructions.
10.4

Adjustments and Calibration

No internal adjustment or calibration is required. There is NO REASON to open the power supply
cover.
Cover removal is allowed only by TDK-Lambda qualified service personnel.
10.5

Parts Replacement and Repairs

As repairs are made only by the manufacturer or by authorized service facilities, no parts
replacement information is provided in the manual. In case of failure, unusual or erratic operation of
the unit, contact the TDK Lambda sales or service facility nearest you.
Further technical assistance, if needed, may be obtained at TDK-Lambda Technical Centre:
https://www.emea.lambda.tdk.com/about_global
MAINTENANCE
CAUTION
187