Table of Contents
Advertisement
B. LAN ➔ Configure ➔ Modify Page
The Modify button on the LAN Configure page allows changing the LAN settings. The available
fields depend on the selection of DHCP Enabled / AUTO IP or Static IP. Changes to these setting
will take place only after clicking the Apply button.
The settings can be changed only by logging-in as 'admin'.
After changing the LAN settings, you are requested to close the web browser.
page. If the change duplicates IP, the
blink,
IP address will revert to the previous state. Press any Front Panel button or encoder to stop
the blinking.
You may be required to perform AC reset of the power supply after changing the LAN settings.
TCP/IP Mode
This selects how the power supply receives network settings. Select one of the following:
•
DHCP Enabled / AUTO IP: This is the default mode. If this mode is selected, the network
server uses DHCP to assign the IP address, subnet mask, default gateway, and DNS
server. Therefore, these fields are disabled (gray) on the web page. If the server cannot
make the assignment, the power supply reverts to the Auto IP method, described in
section 4.7.4.4 on page 67. In this mode, the user can change the hostname and
description only.
The Hostname must not exceed 15 characters.
•
Static IP: If this mode is selected, the IP address, subnet mask, and default gateway must
be entered in the window fields. The settings must be compatible with the requirements of
Figure 4–16: LAN – Changing Settings
NOTE
LAN Status green LED and the Front Panel display will
NOTE
NOTE
79
Re-open the web
Advertisement
Table of Contents
