Table of Contents
Advertisement
7.
Rotate the Voltage encoder until RANGE appears on the voltage display.
8.
Rotate the Current encoder to set 10 (External 10V). Press the Current encoder for selection,
display blinks once to acknowledge the setting.
9.
Exit CONF menu by pressing the Back button or the CONF button.
1. Use a floating outputs programming source to maintain the isolation of the power supply.
2. To prevent damage to the unit, do not program output voltage and/or current above power
supply ratings.
8.5
Connection Diagram
8.5.1
Analog Programming
Follow Figure 8–2 to program power supply output voltage and/or current by Isolated Analog
programming interface.
CAUTION
Figure 8–2: Isolated Analog Programming Wiring
183
Advertisement
Table of Contents
