Table of Contents
Advertisement
1. When connecting multiple power supplies in parallel, these CAN have power sink module
installed (a mix of power supplies with/without power sink module is possible).
2. When connecting multiple power supplies in series, ALL of these MUST have power sink
module installed, otherwise, no power could be absorbed.
3. If power sink module is overloaded, OTP fault is triggered. OTP is seen on the front panel;
power supply output shuts down.
4. When power supply output is turned off, power sink module will remain ACTIVE for 5
seconds.
5. For power sink detailed specification, refer to Safety & Installation Manual, Specifications
section.
NOTES
186
Advertisement
Table of Contents
