Table of Contents
Advertisement
Blink Identify
When this button is clicked, the Master (LAN) power supply Front Panel display and the rear panel
green LAN status LED blinks.
In a multi-drop chain, only the master (LAN) power supply blinks. The blink identification is turned
OFF by clicking this button again or by clicking any button or encoder on the power supply Front
Panel or by SCPI command. Login is not required to use this function.
Measurements
This section displays the selected power supply's actual output Voltage, Current, and operating
mode (constant-voltage, constant-current, constant power, or off). Faults are shown in the voltage
and current display.
Settings
This section displays the selected power supply's output voltage, current limit, and output ON/OFF
settings.
The settings cannot be changed until you have logged-in as 'admin'.
To change a setting, perform the following:
1.
Tick Check to Modify.
2.
Set desired settings. After settings are made, click Apply.
3.
To view the actual settings, deselect Check to Modify.
Faults
For the selected supply, these boxes show any fault which may be active in the supply.
B. DC Power ➔ Protection Page
On the DC Power tab, the Protection button is available at the top of the panel. When opened, the
window allows viewing and setting four protections.
•
Over-Voltage Protection Limit
•
Under-Voltage Limit
•
Fold back Protection
•
Auto-Start or Safe-Start
In a multi-drop chain, these settings affect only the supply selected in the RS-485 address list box.
The settings can be changed only by logging-in as 'admin'.
0.
75
Advertisement
Table of Contents
