Table of Contents
Advertisement
4.7.6.4
Login Rules
•
Up to 2 users may view the web pages of a power supply at the same time. However, the
update rate becomes slower as more web pages are open.
•
Only one user at a time may be logged-in to modify the power supply settings.
•
If an automation program with VISA or socket is running, user may view the web pages
but cannot login to change settings.
•
If a user is logged in, a VISA or socket connection cannot be opened by an automation
program.
•
A user may logout by clicking the Logout button, by closing the web browser, or by leaving
the web browser idle for LAN Keep-alive seconds.
4.7.6.5
DC Power Page
When the DC Power tab is selected, the following web page opens. This page and its sub-menus
allow a user to operate the power supply and adjust its output settings.
A. DC Power ➔ Output Page
When the DC Power tab is selected, the Output page opens by default (GUI).
Refresh List
When this button is clicked, the web page scans to find connected Multi-drop power supplies and
adds the discovered addresses into the list box. This button applies to a multi-drop chain only as
described in section 4.7.1.1.
Click the Refresh List button after clicking the DC power button, after connecting or disconnecting a
power supply, or after changing the RS-485 address.
Select RS-485 Multi-drop Address
This address is described in section 4.7.1.1. This address applies to a multi-drop chain of RS-485
supplies only. If there is no multi-drop chain, only the address of the single LAN supply is available.
Figure 4–11: Output Page
74
Advertisement
Table of Contents
