Table of Contents
Advertisement
Operation Menu
Thermo Fisher Scientific
By pressing NEXT, from the last screen within the main User Screen, the
following screen will appear:
CALIBRATION
********************
YES BACK NEXT
This section describes the Operation menu.
This screen shows the additional "POWER ON"
status code after starting the instrument. Press
NEXT.
Here, the error status is shown. Each character
represents four error bits, assuming values in the
range of 1 and F (hexadecimal: 16). To interpret
the error status, see the "Troubleshooting"
chapter. Press NEXT.
This is the last screen within the main User
Screen, and this shows the current Date
(yy-mm-dd) and Time (hh:mm:ss). To change
these values the keypad must be unlocked. Press
NEXT.
This is the OPERATION menu, press NEXT.
This is the SERVICE menu, press NEXT.
This is the CALIBRATION menu, press NEXT.
Press YES to enter the Operation menu, press
BACK to return to the Main Menu, or press
NEXT to enter the Service menu.
To toggle between the operation via keypad and
serial interface, press the SET key. Please
remember that the parameters cannot be changed
without having enabled the keypad. Press SET.
Model 5030 SHARP Monitor Instruction Manual
Operation
Operation and Service Menus
3-3
Advertisement
Table of Contents
