Table of Contents
Advertisement
RS-232 Commands
Data Protocols with Measuring Network Connection
Data Protocols with
Measuring Network
Connection
Data Sampling
B-8
Model 5030 SHARP Monitor Instruction Manual
u0
reference count rate on
u1
alpha count rate on
ua[Number]
high voltage
range: 0....1600V
ud[Number]
reference threshold range
range: 0....5000 mV
b [Number]
Setting the number of days backwards from the current date for
terminating the file output.
Range: 0...1000 days; 0 will produce the complete file.
Once the character <STX> (usually: Ctrl-B) has been received, the
monitoring instrument MODEL 5030 starts processing the data received at
the serial line according to the protocol that has been agreed upon for
devices operating in a measuring network.
To prevent the measuring instrument from executing data outputs on its
own, we strongly recommend setting the print format to 0.
This is the basic structure of a data protocol:
<STX>[Text]<ETX><BCC1><BCC2>
Instead of <ETX><BCC1><BCC2> it is also possible to send <CR>. In
doing so, the block check will be disabled.
The response of the measuring device will be terminated by <CR><LF>, if
the control or inquiry command had an <CR> at the end. If the command
is terminated with <ETX> (usually: Ctrl-C) and block check, the response
of the measuring instrument will be also terminated with <ETX> and
<BCC1><BCC2>.
Upon request, the measuring instrument sends a measuring data protocol.
Transmission of the measuring data is released by the following sequence of
characters:
<STX>DA[Address]<ETX><BCC1><BCC2>
where Address: Device address, 3 characters, leading zeros can be replaced
by <SP>. It is also possible that the address can be completely dropped. The
address at the measuring instrument is set by using the keyboard. (Menu
OPERATION: Device address).
Thermo Fisher Scientific
Advertisement
Table of Contents
