Table of Contents
Advertisement
Servicing
Chapter 7
This chapter describes how to update the software and replace the Model
5030 SHARP filter tape and carbon vanes of the vacuum pump.
For fault location refer to the "Preventive Maintenance" and
"Troubleshooting" chapters. For additional service assistance, see "Service
Locations" at the end of this chapter.
Safety Precautions
Read the safety precautions before beginning any procedures in this chapter.
WARNING The service procedures in this manual are restricted to qualified
service representatives.
If the equipment is operated in a manner not specified by the manufacturer,
the protection provided by the equipment may be impaired.
14
The Thermo Scientific Model 5030 SHARP contains a small
C (Carbon
14) beta radiation emitting source. Source activity is
100
(micro
<
μCi
curries) which is below the exempt concentration limit defined in 10 CFR,
Section 30.70 - Schedule A. The person with responsibility for the Model
5030 SHARP can return the device to Thermo Fisher Scientific for
14
recycling the
C source.
14
Neither the
C source nor the detector are field serviceable. The Model
5030 SHARP must be returned to the factory for servicing or it can be
serviced by an authorized Thermo Fisher Scientific field service technician.
CAUTION Carefully observe the instructions in each procedure.
Thermo Fisher Scientific
Model 5030 SHARP Monitor Instruction Manual
7-1
Advertisement
Table of Contents
