Configuring The Nac Port - Nortel NAC User Manual

Remote supervisor login

Configuring the NAC port

Configuring the NAC port
Introduction
Configuring the
port
Standard 1.0
This section describes how to prepare a NAC port to remotely
access a Meridian MAX.
To configure the port, follow these steps.
Starting Point: NAC maintenance console
Step Action
1 Complete the procedure described in "Configuring the Meridian
MAX port" on page 104.
2 Verify that the NAC 2.5 system is shut down.
Note: For instructions on how to shut down the system, refer to
the Network Administration Center System Administration and
Maintenance Guide (NTP 553-4011-510), "Maintenance and
administration programs: system running" chapter.
3 Display the NAC Maintenance and Administration menu.
4 Select Configure NAC System.
Result: The Configure NAC System screen appears.
5 Select Port Assignment.
Result: The NAC Communication Port Assignment screen
appears.
Note: For more information on this screen, refer to the Network
Administration Guide (NAC) System Administration and
Maintenance Guide (NTP 553-4011-510), "Maintenance and
administration programs: system shutdown" chapter,
"Configure NAC System" section.
Network Administration Center
User Guide Supplement
107
November 1998