Network Link - Nortel NAC User Manual

32

Network link

Introduction
Configuring for a
network link
Standard 1.0
This section describes how to configure the US Robotics
Sportster 28.8 or 33.6 modems for a network link.
To configure the US Robotics Sportster 28.8 or 33.6 modems
for a network link, follow these steps.
Step Action
1 Open the modem and ensure that the switch settings match the
settings in the following diagram.
2 Set the workstation speed to 9600 baud.
3 Connect a workstation to the modem with a straight-through
cable (NT1R03Dx or NT1R03Ex).
4 Connect the workstation and the modem to their power
sources. Ensure that the modem is connected to the telephone
system with an RJ-11 cable/connector.
5 Power up the workstation and the modem.
6 On the workstation keyboard, type AT&F followed by Enter.
Result: The system responds with OK.
7 Type AT&B1 followed by Enter.
Result: The system responds with OK.
Network Administration Center
User Guide Supplement
Off
On
1 2 3 4 5 6 7 8
Configuring the modems
Network link
G101071
November 1998