Table of Contents
Advertisement
Saving to a file
Printing to a file
Printing to a file
Introduction
Printing reports to
a file
Standard 1.0
After you assign a data stream reporting port, you must prepare
the print settings in NAC 2.5.
If you use MTE 9, follow the steps in this procedure and the
"Printing to a file" section in the MTE 9 User Guide
(P0881398).
To print a report to a file, follow these steps.
Starting Point: NAC 2.5 supervisor workstation
Step Action
1
Display the NAC 2.5 main menu.
2
Select Network Report Definition.
Result: The Network Report Definition submenu appears.
3
Select Report Parameter Definition.
Result: The Report Parameter Definition screen appears.
4
Complete the Report Parameter Definition screen.
Note: For more information, refer to the Network Administration
Center (NAC) 2 Supervisor's User Guide (P0724352), "Network
Report Definition" chapter, "Report Parameter Definition"
section.
5
In the Output Device field, press Options.
Result: A pop-up window appears that displays a list of
devices to use to print the report.
6
Select Data Stream or the name given to the data stream port
in the "Assigning a port" section on page 55.
7
If you want to print this report immediately, press Commands
and select "Print this report."
If you want to print the report at a later time, incorporate the
report into a schedule.
Network Administration Center
User Guide Supplement
57
November 1998
Advertisement
Chapters
Table of Contents
