Additional Software Codes - Nortel NAC User Manual

6

Additional software codes

Introduction
Previous
installation
code
Standard 1.0
System messages appear on your screen when you install the
software. The messages indicate the status of the installation or
upgrade procedure.
Several new lines of installation/upgrade code appear in NAC
2.5 that did not appear in earlier releases of NAC. This section
describes those lines of code.
During a new software installation, the system configures the
port devices. This code is shown in the Network Administration
Center (NAC) Installation Guide (NTP 553-4011-110),
"New software installations" chapter, page 6-17.
During this configuration process, the earlier versions of NAC
displayed the following messages:
***> Configuring port devices...(TIME)
***> Finished configuring port devices.(TIME)
If you are completing reentry point 2, 3, or 4, the following
message appears:
port_hold started.
Stream Error logging started.
netspec "tcpip" not set up.
Line printer scheduler started.
Module ID = NAC00
Network Administration Center
User Guide Supplement
What's new in NAC 2.5
Additional software codes
November 1998