Step 2: Configuring The Wlan Access Port (2230/2231) Before Installation - Nortel 2230l 2231 Quick Install Manual

Networks wlan access port

Hide thumbs

Table Of Contents

Table of Contents

Step 2: Configuring the WLAN Access Port (2230/2231) Before

Installation

Step 2: Config uring th e WLAN A ccess Port (2230 /2231 ) Befo re Installation

The following procedures are designed to make sure that your WLAN Access Port (2230/2231) physical installation goes

smoothly and that initial operation is as expected.

Access Port (2230/2231) for deployment.

Note:

Perform the following procedure on each Nortel Networks WLAN - Access Port (2230/2231) BEFORE

deploying the WLAN Access Port (2230/2231) in its final location.

•

Preparing a Nortel Networks WLAN - Access Port (2230/2231)

series environment

Preparing a Nortel Networks WLAN - Access Port (2230/2231)

If your Nortel Networks WLAN - Access Port (2230/2231) has Operating System 2.0 or a later version loaded on it, continue with

this procedure.

Note:

This procedure assumes that you are preparing a version 2.0 Nortel Networks WLAN - Access Port (2230/

2231) to interoperate with a version 2.0 WLAN Security Switch (2270).

Configuration Setup

Does My AP Qualify for this Procedure?

•

See "How to get help" on page 23

cannot be configured for any reason using the following procedure.

Configuration Steps for a Nortel Networks WLAN - Access Port (2230/2231)

Configure the WLAN Security Switch (2270) in LWAPP Layer 3 Mode and make sure its DS Port is connected to the

network. Use CLI, Web Browser and/or WLAN Management System procedures as described in the WLAN Security

Switch (2270) Quick Installation Guide and the Nortel Networks Product Documentation.

Note:

When you are installing a WLAN Access Port (2230/2231), a DHCP server must be accessible by the WLAN

Access Port (2230/2231).

May 2004