Describing The System Requirements - Nortel NAC User Manual

16

Describing the system requirements

Introduction
Equipment and
material list
Equipment
NAC 2.5 SNN
Cables
Workstations
Standard 1.0
This section describes the hardware and software components
that you require to run NAC 2.5.
NAC 2.5 uses the same hardware components as NAC 2.
However, a new LAN transceiver cable has been added to NAC
2.5.
The following table lists the equipment and materials required
by NAC 2.5.
Contents
• Motorola MVME167-34 single board computer with M68040 33 MHz
CPU
• Motorola MVME332XT/XTS eight-channel asynchronous I/O board
(maximum of five)
• NT7D62CA Mass Storage Unit (contains 1 Gbyte hard disk drive and
600 Mbyte tape drive unit)
• NT7D64AA/DC Application Module power supply (AC or DC)
• NTD19SA Application Module
• three multiport cables (NT8D96BE) for each MVME332XT/XTS
asynchronous communication controller
• LAN transceiver cable (NT7D47EA)
• external input/output cables
• VDT-type (DEC VT520, DEC VT420, DEC VT320, DEC VT220, or
terminals which are 100% compatible
• PC running Reflection 4+ for DOS terminal emulator and directly
connected to the NAC 2.5. All PCs supported by Reflection are
supported by NAC 2.5.
• PC running MTE 9 and connected to the NAC 2.5 (either directly or
through a LAN connection). For more information on PC
requirements, refer to the MTE 9 User Guide (P0881398).
Network Administration Center
User Guide Supplement
Preparing the system
Describing the system requirements
November 1998