Using The Mvme332Xts Or Mvme332Xt Card - Nortel NAC User Manual

Preparing the system

Using the MVME332XTS or MVME332XT card

Using the MVME332XTS or MVME332XT card
Introduction
Similarities
between the
MVME332XTS and
MVME332XT
Differences
between the
MVME332XTS and
MVME332XT
Standard 1.0
This section describes how to use the MVME332XTS or the
MVME332XT eight-channel asynchronous board to connect the
NAC 2.5 module with all external devices. The MVME332XTS
card is a new feature in NAC 2.5.
The MVME332XTS uses the same configuration as the
MVME332XT card.
For more information on this configuration, refer to the Network
Administration Center (NAC) Installation Guide
(NTP 553-4011-110), "Hardware installation" chapter,
"MVME332XT eight-channel asynchronous board" section.
The MVME332XTS card has two light-emitting diodes (LEDs)
on the faceplate. There are three LEDs on the faceplate of the
MVME332XT.
The LEDs show the following conditions:
• FAIL This red LED illuminates when a hardware failure
occurs on the card.
• HALT This red LED is steadily illuminated when the
processor stops.
• RUN This green LED illuminates almost continuously
and flickers every few seconds when applications
run normally. This indicator appears only on the
MVME332XT card.
Network Administration Center
User Guide Supplement
21
November 1998