Configuring The Hardware - Nortel NAC User Manual

Remote supervisor login

Configuring the hardware

Configuring the hardware
Introduction
Required cables
and modems
Preparing the
hardware
Standard 1.0
This section describes how to configure the hardware to obtain
remote access to the Meridian MAX nodes.
You need two NT7D99AA modem cables and two dial-up
modems to create a remote connection between the NAC and
the Meridian MAX node.
To configure the NAC and Meridian MAX hardware, follow
these steps.
Step Action
1 Configure the modems for remote diagnostics.
Note: For more information on how to configure a US Robotics
Sportster 28.8 or 33.6 modem, refer to "Remote supervisor
login" on page 31. For information on how to configure on other
modems, refer to the Network Administration Center (NAC)
Installation Guide (NTP 553-4011-110), "Peripheral devices"
chapter, "Dial-up supervisor modems" section.
2 Use the following diagrams to help you connect the cables
between the modems and the telephone network.
Network Administration Center
User Guide Supplement
101
November 1998