Table of Contents
Advertisement
Configuring the modems
Network link and Racal VI2422PA modem
Network link and Racal VI2422PA modem
Introduction
Configuring for a
network link
Standard 1.0
This section describes how to configure the Racal VI2422PA
modem for a network link.
You only need to configure the modem on the Meridian MAX
side. NAC 2.5 automatically configures the modem on its side.
To configure the Racal VI2422PA modem for a network link,
follow these steps.
Step Action
1
Connect the Meridian MAX workstation to the modem with a
straight-through NT9D9007 cable.
Note: The workstation must be connected with a data format of
8N1 and a speed of 2400 baud.
2
Verify that the modem is connected to the telephone system
with an RJ-11 cable/connector.
3
Connect the Meridian MAX workstation and the modem to a
power source.
4
Power up the workstation and modem.
5
On the workstation keyboard, type AT&F followed by Enter.
Result: The system responds with OK.
6
Type AT*F0 followed by Enter.
Result: The system responds with OK.
7
Type AT*ZT=####### followed by Enter.
Result: The system responds with OK.
Note: The "#######" represents the telephone number for the
Meridian MAX node.
8
Type ATQ1 followed by Enter.
Result: The system does not show a response.
Network Administration Center
User Guide Supplement
37
November 1998
Advertisement
Chapters
Table of Contents
