Nortel NAC User Manual page 107

96
Reconfiguring the
node numbers
Standard 1.0
Step Action
10 Select "Save changes and exit."
Note: The changes take effect after you restart the NAC 2.5
system.
11 Select Network Definition from the Configure NAC System
menu.
Result: The NAC Network Definition/Installation screen
appears.
12 Reenter the node information that you deleted in Steps 5
and 6.
13 Press PF1 to display the Commands menu.
14 Select "Save changes and exit."
Note: The changes take effect after you restart the NAC 2.5
system.
15 Restart the NAC 2.5 system.
To print reports that contain the new node and the reassigned
node, you must clean up the existing node configuration and
reconfigure the correct information in the NACD-DN, CDN,
and List Management definitions.
To reconfigure the node numbers, follow these steps.
Starting Point: Parameter Administration submenu in NAC 2.5
Step Action
1 Complete the steps described in the previous procedure
("Defining the new node" on page 94).
2 Display the Parameter Administration submenu.
Note: For more information on the Parameter Administration
submenu, refer to the Network Administration Guide
Supervisor's User Guide (P0724352), "Parameter
Administration" chapter.
Network Administration Center
User Guide Supplement
Configuring 10+ nodes
Configuring the nodes
November 1998