Configuring The Nodes - Nortel NAC User Manual

Configuring 10+ nodes

Configuring the nodes

Configuring the nodes
Introduction
Before you begin
Identifying nodes
to be reassigned
Standard 1.0
This section describes the steps to follow if you want your
NAC 2.5 to monitor nodes that contain Meridian MAX 8 (or
lower) applications.
If you follow these steps, your NAC 2.5 can monitor up to 20
nodes. Some of these nodes can contain Meridian MAX 8 (or
lower) applications.
Note: You can configure a maximum of 10 nodes to monitor
Meridian MAX 8 (or lower) applications.
Back up your data before you begin the configuration process.
For more information on how to back up data, refer to the
Network Administration Center System Administration and
Maintenance Guide (NTP 553-4011-510), "Maintenance and
administration programs: system shutdown" chapter, "Backup
and Restore Utilities" section.
The Meridian MAX 8 (or lower) applications must occupy one
of the first 10 nodes. You must determine which of these nodes
are occupied by Meridian MAX 9 (or higher) applications.
To identify the nodes that are occupied by Meridian MAX 9 (or
higher) applications, follow these steps.
Starting Point: NAC 2.5 workstation
Step Action
1 Display the NAC 2.5 main menu.
Network Administration Center
User Guide Supplement
87
November 1998