Configuring Mte - Nortel NAC User Manual

Using the Meridian Terminal Emulator

Configuring MTE

Configuring MTE
Introduction
Configuring the
MTE
Standard 1.0
After you configure a direct, modem, or LAN connection, you
must configure the MTE to work with NAC 2.5.
To configure the MTE, follow these steps.
Starting Point: NAC 2.5 maintenance console
Step Action
1 Configure a serial, direct, or LAN connection in NAC 2.5.
For information on how to configure a direct or modem
connection, refer to "Connecting through a serial port or
modem" on page 42.
For information on how to configure a LAN connection, refer to
"Connecting through a LAN connection" on page 48.
2 Install MTE 9 on your PC.
For information on how to install MTE 9, refer to the MTE User
Guide (P0881398), "Installing MTE" chapter.
3 Configure the MTE to work with NAC 2.5.
For information on how to connect to MTE through a serial port,
refer to the MTE User Guide (P0881398), "Connecting to an
application" chapter, "To connect using a serial port" section.
For information on how to connect to MTE through a modem,
refer to the MTE User Guide (P0881398), "Connecting to an
application" chapter, "To connect using a modem" section.
For information on how to connect to MTE through a LAN
connection, refer to the MTE User Guide (P0881398),
"Connecting to an application" chapter, "To connect using a
LAN" section.
Network Administration Center
User Guide Supplement
51
November 1998