Nortel NAC User Manual page 102

Configuring 10+ nodes
Configuring the nodes
Assigning the
ports
Standard 1.0
You must assign a new port for each new node. If an existing
port is not being used by another device, you can use it instead
of creating a new port.
To assign a port, follow these steps.
Starting Point: NAC 2.5 maintenance console
Step Action
1 Verify that the NAC 2.5 system is shut down.
Note: For instructions on how to shut down the system, refer to
the Network Administration Center System Administration and
Maintenance Guide (NTP 553-4011-510), "Maintenance and
administration programs: system running" chapter.
2 Display the NAC Maintenance and Administration menu.
3 Select Configure NAC System.
Result: The Configure NAC System screen appears.
4 Select Port Assignment.
Result: The NAC Communication Port Assignment screen
appears.
Note: For more information on this screen, refer to the Network
Administration Guide (NAC) System Administration and
Maintenance Guide (NTP 553-4011-510), "Maintenance and
administration programs: system shutdown" chapter,
"Configure NAC System" section.
Network Administration Center
User Guide Supplement
91
November 1998