Connecting Through A Serial Port Or Modem - Nortel NAC User Manual

42

Connecting through a serial port or modem

Introduction
Setting the
terminal type
Standard 1.0
This section describes how to configure NAC 2.5 to work with
MTE 9 through a serial port or modem.
To prepare the NAC 2.5 to run with MTE 9, you must set the
terminal type to "MTE 9 or above."
To set the terminal type, follow these steps.
Starting Point: NAC 2.5 maintenance console
Step Action
1 Verify that the NAC 2.5 system is shut down.
Note: For instructions on how to shut down the system, refer to
the Network Administration Center System Administration and
Maintenance Guide (NTP 553-4011-510), "Maintenance and
administration programs: system running" chapter.
2 Display the NAC Maintenance and Administration menu.
Network Administration Center 2.5
User Guide Supplement
Using the Meridian Terminal Emulator
Connecting through a serial port or modem
November 1998