Nortel NAC User Manual page 41

30
Standard 1.0
Step Action
4 Connect the workstation and the modem to their power
sources. Ensure that the modem is connected to the telephone
system with an RJ-11 cable/connector.
5 Power up the workstation and the modem.
6 On the workstation keyboard, type AT&B1&W&W1
Result: The system responds with OK.
7 Power off the modem.
8 Configure the modem's switch settings to match the settings in
the following diagram.
Phone jacks
9 If you are configuring the remote end and wish to dial the
telephone number of the NAC 2.5 modem, use the Hayes AT
command "atdt####" for touch-tone dialing, or "atdp####" for
pulse dialing.
Note: The "####" is the telephone number of the NAC 2.5
modem.
Network Administration Center
User Guide Supplement
Configuring the modems
Dip switches Serial port interface
1 2 3 4 5 6 7 8
Black =
switch position
(up or down)
1 2 3 4 5 6 7 8
Remote diagnostics
Power
G100426
November 1998