Assigning A Port - Nortel NAC User Manual

Saving to a file

Assigning a port

Assigning a port
Introduction
Assigning a port
for data stream
reporting
Standard 1.0
You can assign all of your printer ports, except one, to data
stream reporting. You must reserve one non-data stream printer
for use by the system.
To assign a port for data stream reporting, follow these steps.
Starting Point: NAC 2.5 maintenance console
Step Action
1 Verify that the NAC 2.5 system is shut down.
Note: For instructions on how to shut down the system, refer to
the Network Administration Center System Administration and
Maintenance Guide (NTP 553-4011-510), "Maintenance and
administration programs: system running" chapter.
2 Display the NAC Maintenance and Administration menu.
3 Select Configure NAC System.
Result: The Configure NAC System screen appears.
4 Select Port Assignment.
Result: The NAC Communication Port Assignment screen
appears.
5 Move the cursor to the port to be used for data stream
reporting.
6 Press PF2 to view a pop-up menu that lists the available
devices.
7 From the pop-up menu, select Data Stream.
Result: The entry appears in the Device field.
8 Ignore the Connect and Baud fields.
9 In the Name/Comment field, enter a name to indicate that this
port is assigned to data stream reporting.
10 Press PF1 to use the Commands menu to save and exit.
Network Administration Center
User Guide Supplement
55
November 1998