Table of Contents
Advertisement
Remember that certain solvents can cause skin
rashes and are usually flammable. Do not inhale sol-
vent vapour.
Store flammable starting aids in a cool, well venti-
lated location. Remember that such aids (starting
gas) must not be used in connection with preheating
of the induction manifold.
Keep the work place clean. Oil and/or water on the
floor makes it slippery.
Oil and/or water in close proximity to electrical equip-
ment or electrically powered tools are dangerous
and any spills should be cleaned up immediately.
Oily clothes are a serious fire hazard.
Check daily that the machine and equipment are free
from dirt and oil. In this way the risk of fire is reduced
and it is easier to detect faulty or loose components.
‹ CAUTION
If a high pressure jet is used for cleaning, take
great care as the insulation of electrical leads
can become damaged even at a moderately high
pressure and temperature.
‹ WARNING
Do not point the high pressure jet at personnel.
Check if the electric leads have been damaged by
chafing which could lead to a short circuit and fire.
Check that there is no damage to hydraulic and
brake hoses caused by chafing.
‹ CAUTION
Switch OFF the battery disconnect switch or dis-
connect the batteries, when welding on the
machine.
Welding and grinding may only be done on the ma-
chine when it is placed in a clean area where there
are no fuel tanks, hydraulic pipes or similar lying
around. Take extra care when welding and grinding
near flammable objects. A fire extinguisher should
be kept handy.
Refrigerant R134a
The air conditioning system contains refrigerant
R134a. Servicing, refilling or emptying of the refrig-
erant R134a must only be done by trained and
qualified service personnel.
54
‹ WARNING
Refrigerant R134a can cause frostbite, if it
comes into contact with bare skin
‹ WARNING
The air conditioning system is pressurised.
Never loosen the filling plug on the compressor
or any hose and pipe unions, as an unintentional
leak could result. If a leak is suspected, do not try
to refill the system. Contact your BELL
EQUIPMENT Representative .
Avoid breathing in the air conditioner refrigerant and
lubricant vapour or mist. Exposure may irritate the
eyes, nose and throat.
The refrigerant is under high pressure and the sys-
tem must be serviced by qualified personnel only.
Improper service methods may cause injury.
If accidental system discharge occurs, ventilate the
work area before resuming work.
Additional health and safety information may be ob-
tained
from
your
manufacturers.
Working on Painted Surfaces
When welding and cutting, the paint must first be re-
moved up to a distance of 100 mm (4") from the
welding or cutting point. Paint which is heated gives
off unhealthy gases.
Ideally paint should be removed using sand blasting.
If the paint cannot be removed using sand blasting, it
must be removed in some other way for example us-
ing paint stripper or a high speed grinder.
Note: When using paint stripper or a high speed
grinder, you must use a portable air extractor, safety
glasses and protective gloves.
Working with Polymer Material
Polymer materials, such as rubber and certain kinds
of plastics, can give off gases when heated.These
gases can be dangerous to your health and to the
environment.
The following protective measures should be taken:
• Protect the polymer material from heat before
welding or cutting near the material.
• Do not burn polymer materials when disposing
of them.
refrigerant
and
lubricant
870984-01
June 1, 1999
Advertisement
Table of Contents
