Table of Contents
Advertisement
There are several safety decals on your BELL EQUIPMENT machine. Their exact location and description of
the hazard are reviewed in this section. Please take the time to familiarise yourself with these safety decals.
Keep the decals clean by using a soft cloth, water, and soap. Do not use solvent, gasoline, etc. You must replace
a decal if it is damaged, missing or cannot be read. If a decal is on a part that is replaced, ensure a new decal is
installed on the replacement part. Contact your BELL EQUIPMENT Representative for new decals.
204606
Located on the side window and on both sides of the
mudguard and inside the cab
204607
Located on the park brake actuator.
204615
Located on the pressurised components.
204619
Located on the suspension cylinders.
870984-01
June 1, 1999
SAFETY DECALS
WARNING
DO NOT OPERATE OR WORK
ON THIS MACHINE UNLESS
YOU HAVE READ AND
UNDERSTOOD THE
INSTRUCTIONS AND WARNINGS
IN THE OPERATORS MANUAL
FAILURE TO FOLLOW THE
INSTRUCTIONS OR HEED THE
WARNINGS COULD RESULT IN
PERSONAL INJURY OR DEATH
WARNING
SPRING UNDER
PRESSURE
READ MAINTENANCE
MANUAL BEFORE
CARRYING OUT
MAINTENANCE
IN THIS AREA
WARNING
COMPRESSED AIR
RESERVOIR
DRAIN COMPLETELY
BEFORE CARRYING
OUT MAINTENANCE
WARNING
PRESSURISED GAS
REFER TO OPERATORS
MANUAL FOR CORRECT
DISASSEMBLY
PROCEDURE
204616
Located on both sides of the rear chassis.
204617
Located on the left mudguard next to the cab lift
pump.
204618
Located on the rear of the machine.
204620
Located on each side of the articulation assembly.
WARNING
INSTALL BIN
SUPPORT POLE
BEFORE CARRYING
OUT ANY
MAINTENANCE
IN THIS AREA
WARNING
INSTALL CAB
SUPPORT POLE
BEFORE CARRYING
OUT ANY
MAINTENANCE
IN THIS AREA
WARNING
MACHINE OPERATOR
HAS LIMITED VISIBILITY
DO NOT REMAIN IN THIS
AREA WHILE MACHINE
IS RUNNING
WARNING
INSTALL
ARTICULATION
LOCK BEFORE
CARRYING OUT
ANY MAINTENANCE
IN THIS AREA
iv
Advertisement
Table of Contents
