Table of Contents
Advertisement
10. Fill the oil filter bowl with oil. Refer to
tions, Chapter 1
lubricants and coolant.
‹ CAUTION
It is important to fill the oil filters with oil before
fitting. This ensures lubrication directly after
starting the engine.
11. Position the filter bowl to the centre of the filter
head, insert the retaining bolt and tighten it to 45
N⋅m (10 ft lb).
Note: After replacing the oil filters, allow the machine
to run at low idle for at least one minute.
Fill the Engine with Oil
1
1. Clean the oil filler cap (1) and the area around it.
2. Remove the oil filler cap.
3. Fill with oil until the oil level is on the upper mark
on the dipstick. Refer to
ter 1 - Recommended Fuels, Lubricants and
Coolant Additives.
‹ CAUTION
Do not overfill the engine with oil.
4. Check continuously during the filling procedure
to ensure that the engine oil level reaches the
upper mark on the dipstick.
‹ CAUTION
Re-fit the oil filler cap securely.
76
Specifica-
for recommended fuels,
f002020
Specifications, Chap-
Clean the Fuel Screen
1
1. Unscrew and remove the fuel screen reservoir
(1).
2. Carefully remove the spring (1), fuel screen (2)
and sealing ring (3) from the fuel screen reser-
voir (4).
3. Inspect all the components for damage and re-
place if necessary.
4. Place the components in a container with clean
fuel.
f002021
1
2
3
4
f000602
870984-01
June 1, 1999
Advertisement
Table of Contents
