Table of Contents
Advertisement
Symptom
Increased stopping distances
Squealing noise from the brakes
when applied
Brakes do not fully release
Symptom
Final drive leaking oil
Noisy final drive
Final drive overheating
Differential assembly leaking oil
Differential assembly noisy
Differential assembly overheating
870984-01
June 1, 1999
Brakes Trouble Shooting
Possible Cause
Worn brake pads
Oil or grease on the brake pads
Hydraulic brake components leaking Contact your BELL Product Support
Brake pads glazed
Brake discs warped or scored
Brake caliper pistons sticking
Hydraulic brake components defec-
tive
Axle Trouble Shooting
Possible Cause
Loose or damaged oil plugs
Oil level too high
Final drive bolts loose
Axle breather blocked
Low oil level in the final drive
Oil level too high
Oil level too low
Bolts loose on main housing
Oil level too low
Oil level too high
Oil level too low
Axle breather blocked
Remedy
Change the brake pads
Check and repair the cause of the oil
or grease leak. Change the brake
pads
Representative
Change the brake pads
Inspect the brake discs for damage
Change the brake caliper
Contact your BELL Product Support
Representative
Remedy
Tighten or replace the oil plugs
Drain oil to the correct level
Tighten the final drive bolts to the
correct torque
Clean the axle breather
Refill the final drive. Refer to
ommended Fuel, Lubricants and
Coolant Chart
Drain oil to the correct level
Refill the final drive. Refer to
ommended Fuel, Lubricants and
Coolant Chart
Tighten bolts to the correct torque
Refill the differential. Refer to
fications
for the
Recommended
Fuels, Lubricants and Coolants
Drain the oil to the correct level
Refill the differential. Refer to
fications
for the
Recommended
Fuels, Lubricants and Coolants
Clean the axle breather
Rec-
Rec-
Speci-
Speci-
117
Advertisement
Table of Contents
