Table of Contents
Advertisement
Adjust the Drive Belts
Adjust the Alternator Drive Belts
1
1. Slacken the securing bolt (1) on the alternator.
2. Tighten the adjusting nut (2) to increase the ten-
sion of the drive belts.
3. Use the tension tester to measure the tension.
Refer to Check the Drive Belt Tensioning (previ-
ous instruction).
4. Repeat the procedure until the correct tension is
achieved then tighten the securing bolt.
Adjust the Air Conditioner Compressor
Drive Belts
2
1
1. Loosen the adjusting bolts (1) and (2) and
manually move the air conditioner compressor
forward on the bracket (3) to apply tension to the
drive belts.
2. Secure the adjusting bolts.
3. Measure the drive belt tension. Refer to Check
the Drive Belt Tensioning in this Chapter.
4. On obtaining the correct tension ensure that the
adjusting bolts are secure.
870984-01
June 1, 1999
Clean the Cooling Pack
1. Raise the bonnet and switch off the battery dis-
2. Wash the cooling pack from the rear using a
2
3. Keep the fins free from obstructions which may
Note: If there has been transmission failure the fluid
cooler must be sent in for ultrasonic cleaning. Con-
tact BELL EQUIPMENT Product Support.
Check the Accelerator Throttle Linkage
and the Throttle Position Linkage
F000991
1. Check the accelerator throttle linkage (1) and
Contact BELL EQUIPMENT Product Support to ad-
3
just the linkages.
F000973
connect switch.
pressure washer and a mild detergent that is not
caustic to aluminium.
restrict the air flow.
1
the throttle position linkage (2) for damage and
security.
2
f002015
79
Advertisement
Table of Contents
