Frame And Body - Bell B40C 6X6 Operator's Manual

2
11. If necessary, adjust the headlight using the ad-
justment screws (1) and (2) to move the light
beam to the left or right, or up and down.
12. Blackout the outer left headlight and uncover the
inner left headlight.
f
d
HOT SPOT
CENTRE
WALL PATTERN : HIGH BEAM
13. Select high beam and check that the headlight
hot spot centre is where lines (a) and (d) inter-
sect.
14. If necessary, adjust the headlight using the ad-
justment screws.
15. Blackout the inner left headlight and uncover the
inner right headlight.
16. With the headlights still set on high beam check
that the headlight hot spot centre is where lines
(a) and (e) intersect.
17. If necessary, adjust the headlight using the ad-
justment screws.
18. Blackout the inner right headlight and uncover
the outer right headlight.
110
1
F000399
c e g
x
h
S000508
19. Select dipped beam and check that the horizon-
tal cut-off line is not above line (b) and that the
diagonal cut-off line tapers off to the 10 o'clock
position.
20. If necessary, adjust the headlight using the ad-
justment screws.
21. Uncover and switch OFF the headlights when
the adjustment is correct.

Frame and Body

Adjust the Bonnet
1
1. If the latch is not aligned with the catch, adjust
the latch position by re-setting the back plate po-
a
sition and securing with the bolts (2) .
b
Change the Wiper Blades
1. Unscrew and remove the two screws (1) secur-
ing the wiper blade assembly to the wiper arm.
F000997
1
F000669
870984-01
June 1, 1999