Table of Contents
Advertisement
Figure 7.
Linux Console
Note:
The .bat or shell script checks the Java environment settings, copy necessary files,
and give some prompts if the environment is not set up correctly.
The GUI displays the application tab corresponding to the design running in the FPGA.
If the design loaded in the FPGA is not supported by the BTS GUI, you receive a
message prompting you to configure your board with a valid BTS design. For more
information, refer to the Configure Menu section.
4.2. Test the Functionality of the Development Kit
This section describes each control in the BTS.
4.2.1. The Bottom Info Bar
The bottom information bar shows the status of the system connection, the Intel
Quartus Prime version and the JTAG clock.
•
System Connected/Disconnected: Shows if the board is connected to the
system. The green sign turns gray if the board becomes disconnected.
•
Intel Quartus Prime Version: Displays the current Intel Quartus Prime version
installed and active on your system. The text turns red if your version is older
than the required version. Change the
you have installed the right version but the active version doesn't meet the
requirement.
•
JTAG: Displays the JTAG clock frequency.
4.2.2. The Configure Menu
Use the Configure Menu to select the design you want to use. Each design example
tests different functionality that corresponds to one or more application tabs.
®
™
Intel
Agilex
F-Series FPGA (Two F-Tiles) Development Kit User Guide
16
environment variable if
QUARTUS_ROOTDIR
4. Board Test System
739942 | 2022.09.21
Send Feedback
Advertisement
Table of Contents
