The Xcvr Tab - Intel Agilex F Series User Manual

4. Board Test System
739942 | 2022.09.21
User LEDs
The User LEDs control displays the current state of the user LEDs. Toggle the LED
buttons to turn the board LEDs on and off. Click the All button to reverse the state of
all the LEDs.
2
I C
The read-only I
devices, which can be accessed by I
can be updated in real time.
Platform Designer Memory Map
The Platform Designer Memory Map control shows the memory map of
bts_config.sof design running on your board.

4.2.5. The XCVR Tab

The XCVR tab allows you to run transceiver tests on your board. You can run the test
using either electrical loopback modules or optical fiber modules.
4.2.5.1. The QSFP NRZ Tab
Figure 11. The QSFP NRZ Tab
The following sections describe controls in the QSFP NRZ tab.
Status
The Status control displays the following status information during the loopback test:
• PLL Lock: Shows the PLL locked or unlocked state.
• Pattern Sync: Shows the pattern synced or not state. The pattern is considered
synced when the start of the data sequence is detected.
• Detail: Shows the PLL lock and pattern sync status of each channel. The number
of the error bits of each channel can be found here.
Send Feedback
2
C target device control displays the connection status of some
2
C bus. The status of QSFP and QSFPDD modules
®
Intel Agilex
™
F-Series FPGA (Two F-Tiles) Development Kit User Guide
19